Step-by-Step Guide: How to Apply Press-On Nails Using Jelly Adhesive Tabs

Introduction

Jelly adhesive tabs are a beginner-friendly and non-damaging option for applying press-on nails. This step-by-step guide will help you achieve a secure, long-lasting manicure with minimal effort. Follow these detailed instructions to perfect your application process and get salon-quality nails in minutes!

Tools You’ll Need:

• Jelly Adhesive Tabs
• Cuticle Pusher (Wooden Stick)
• Nail Buffer or File
• Alcohol Pads

Step-by-Step Application Process

Step 1: Prep Your Nails

• Wash your hands thoroughly with soap and water to remove dirt and oils.
• Dry your hands completely to ensure clean nail beds.

Step 2: Push Back Cuticles

• Use a wooden cuticle pusher to gently push back the cuticles around your nails.
• If needed, use a cuticle trimmer to remove any excess dead skin for a smooth surface.

Step 3: Buff and Shape

• Lightly buff the surface of your nails using a nail buffer or file.
• This step helps to remove shine, allowing better adhesion of the jelly tabs.
• Shape your nails as desired using the nail file.

Step 4: Clean Your Nails

• Use an alcohol pad to wipe your nail surface and surrounding skin.
• This step removes any remaining oils or debris, ensuring maximum adhesion.

Step 5: Select the Correct Jelly Tab

• Choose a jelly adhesive tab that matches the size and shape of your nail.
• The adhesive should cover your entire nail bed without extending over the edges.
  Tip: Adjust the size to fit your nail perfectly.

Step 6: Heat the Jelly Tab for Better Adhesion

• Use a hair dryer to blow warm air on the jelly tab for 30 seconds or place it under a baking lamp for 30 seconds.
• P.S.: Avoid touching the adhesive side of the jelly tab with your fingers to prevent reducing its stickiness.

Step 7: Position the Jelly Tab on Your Nail

• Align the jelly tab 1mm away from the base of your nail (near the cuticle) and stick it down.
• Press firmly around the edges to eliminate any air bubbles.
• P.S.: Adjust the placement based on your nail shape to ensure a snug and secure fit.

Step 8: Smooth the Jelly Tab Across the Nail

• Use your fingertip or a wooden cuticle pusher to press down the jelly tab evenly, ensuring it covers the entire nail surface.
• Push gently from the center outward to the edges, smoothing the jelly tab until it adheres firmly.
• Once done, peel off the protective film from the top of the jelly tab.

Step 9: Position the Press-On Nail

• Hold the press-on nail at a 45-degree angle, aligning it approximately 2mm above your cuticle area.
• Ensure the nail tip is positioned correctly before pressing it down.

Step 10: Slide the Nail into Place

• Gently push the press-on nail down toward your cuticle area until it sits snugly along the edge of your natural nail.
• Make sure it aligns perfectly with your nail shape for a seamless look.

Step 11: Secure and Eliminate Air Bubbles

• Press the nail down firmly in the center and hold for a few seconds.
• Gradually apply pressure along the edges and around the nail to remove any air bubbles and ensure a secure fit.
• Focus on the corners to ensure the adhesive bonds completely with the nail.

Step 12: Avoid Water for 3 Hours

• After applying your press-on nails, avoid contact with water for the next 3 hours to ensure the adhesive sets properly.
• For best results, it is recommended to apply the nails before bedtime, allowing them ample time to bond securely overnight.

Conclusion

By following these steps, you can enjoy beautiful, long-lasting press-on nails with minimal effort. Jelly adhesive tabs are perfect for beginners or anyone seeking a damage-free manicure solution. Explore your favorite nail styles and enjoy a flawless application every time!